Rena MACH 5 Instrukcja Naprawy Pobierz pdf (Strona 107)

SECTION 6

TROUBLESHOOTING

101

Fuzzy/Distorted Print

Fuzzy/distorted print can occur for a number of reasons; listed/shown below.

Problem: Poor original image quality (less than 300 dpi).

Solution: Use high quality images.

Problem: Choosing to print image in low resolution from software application.

Solution: Set image to highest resolution possible from software application.

Problem: Paper is buckling or bowing during the time of printing.

Solution: Try removing the PPS spacers. Try printing on a thicker piece of media (i.e. 40lb paper ) If

problem does not occur on heavier material the media you are feeding may be too flimsy.

Problem: Damaged Printhead nozzle surface; scratched from improper manual cleaning, or dirty/damaged

wiper roller.

Solution: Only use distilled water and a non-abrasive, lint free cloth to manually clean the printhead.

Replace the wiper roller at the same time the printhead is replaced. Cover the printer, when not in use, to

keep dust/debris (plaster dust) from entering the printer.

Fuzz/Distorted Print Example:

Good Print Example:

Fuzzy/Distorted

Print Example

Good Print

Example

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 127 128

Brak uwag

Rena MACH 5 Instrukcja Naprawy Strona 107